Plasma Chemistry JAX_PLC_001

Jump to:


Clinical chemistry determines biochemical parameters in plasma including enzymatic activity, specific substrates and electrolytes.

Ontological description: MP:0001545 – blood physiology abnormalities.


Experimental Design



  1. Clinical chemistry analyser
  2. Refrigerated centrifuge
  3. Eppendorf tubes
  4. Pipettes (200-1000 ul)


Set up the clinical chemistry analyser and perform QC analyses of the control reagents in accordance with the equipment guidelines.

Sample collection and preparation:

  1. Collect the appropriate volume of blood required (160-200μl of plasma), for the clinical chemistry analyser being used for assessment, in a  BD Microtainer tube containing Lithium Heparin with the relevant blood collection procedure (see IMPC protocol Blood collection by retro-orbital puncture). Time of day for collection is in the morning, starting no earlier than 07:30.
  2. Keep whole blood samples on ice until centrifugation. If plasma samples cannot be analysed immediately, keep them in the fridge until analysis.
  3. Analysis of samples is optimally done on the day of collection. When not possible the plasma samples can be stored at 2-8°C. If samples require storage for > 48 hours, freeze plasma at -20 °C in single aliquots. All samples are allowed to come to room temperature prior to analysis.
  4. Use plasma samples undiluted or diluted to a ratio of 1:2 with deionised water if the volume is insufficient.
  5. briefly centrifuge them at ~5000 x g for 10 minutes. If necessary, remove fibrin clots using a wooden applicator.


Blood collection for Clinical Chemistry and Hematology is performed as a fasting (after 4 hours) procedure, with some mice being used for subsequent gross pathology and other clinic-specific parameters included in terminal assessments.

Dilution. Dilution of blood is highly discouraged, but is allowed when the total necessary amount is not obtained. If dilution is necessary then the assays should be done in one run.

  1. Plasma samples must be free of Fibrin clots in order to be analysed.
  2. Each morning, all parameters are tested with control sera (see ESLIM_015_001_Annex_3: Controls for biochemistry on AU400). Some parameters are tested with control serum level 1 (Beckman Coulter System Reagent, ODC0003) and control serum level 2 (Beckman Coulter System Reagent, ODC0004), which consists of lyophilised human plasma with a normal and a pathological concentration. Other parameters are tested with specific controls from other suppliers.
  3. Controls are thawed and vortexed before utilisation and loaded according to the analyser’s display. Control values must lie within the acceptable range indicated by the manufacturer, otherwise the specific tests must be recalibrated and specific measurements repeated. Controls can be stored in 200μl aliquots at -20°C for up to 1 week.

Parameters & Metadata


Name Version Type Description Req. Upload Req. Analysis Annotation Increment Options Ontology Options Unit Data Type Derived History Key Group ID
Name Version Type Description Req. Upload Req. Analysis Annotation Increment Option Ontology Options Unit Data Type Derived History Key Group ID