Histopathology Placenta E9.5 IMPC_HPL_001

Purpose

This protocol is used when a Complete Mouse Pathology Phenotype is requested. It is used to standardize the collection, trimming and embedding of embryonic tissue.

Experimental Design

  • Set up timed matings with heterozygous mice
  • Day 0 is defined as the midpoint of the prior dark cycle following the identification of a copulation plug.
  • Collect embryos at E14.5-E15.5 at least, 1 Male , 1 Female homozygotes, and 1 WT control and score.

Equipment

Feather No. 4 Surgical Blade Handle
No. 4 Surgical Blade
Forceps
Blue Cassettes
Lense paper 10cmx10cm

Procedure

Embryo Dissection
1. Dissect embryos from dam.
2. Place embryos in 37°C PBS (minus Ca/Mg) containing 1 ul of Heparin per 1ml PBS (stock concentration of Heparin at 1,000u/ml).
3. Remove extra-embryonic membranes and placenta and collect yolk sac for genotyping; cut umbilical vessels with small scissors.
4. Check embryos for bleeding after 5 minutes especially the E15.5. If not visibly bleeding a clot may have formed at the end of the umbilical vessels. Remove clot by cutting vessels below the clot.
5. Allow embryos to bleed out (on rocker) in warm PBS/Heparin for a maximum of 15 min.

6. Wash embryos 2x with PBS.
7. Ensure the embryos are dead (by exsanguination) before immersing in 4% paraformaldehyde fixative prepared in PBS (check for movement or response to stimulus). For E15.5 embryos, fix overnight at 4oC; Embryos should be fixed in 20 – 40 X volume of fixative to embryo volume.
8. When fixation is complete, remove fix and immerse and store embryos at 4oC in PBS containing sodium azide (0.1g/500ml PBS) until they are imaged.
E15.5 embryos are bisected sagittally. E15.5 embryos are processed on a 2 day processing schedule.
Specimens are now ready to be cut at 4μm (one section is cut laterally to include kidney and one section is cut midline) and then stained with H&E on autostainer and coverslipper.

 

E15.5 Embryo Trimming into Cassettes for Processing
1. Cassette 1: Bisect embryo saggital midline (unless indicated otherwise by OPT) and place embryo sagittaly in middle of lens paper and wrap gently making sure all edges are enclosed. Place in the labelled cassette.
2. Cassette 2: Cut placenta cross section through the midline (use umbilical cord as midline). Place both halves and yolk sac in lense paper and wrap gently making sure all edges are enclosed.
3. Proceed with steps 5-7 above.
4. Embed Cassette 1 embryo sagittally (on its side) in paraffin.
5. Embed Cassette 2 placenta (on cut surface) and yolk sac on edge (cross section)

 

Embryo Orientation in Cassettes for Embedding
Embryos are embedded in paraffin with the cut surface down. Exceptions are noted in the table below*.

Block # Tissue Sample(s) Embedding Orientation Number of Tissues
1 Whole Embryo Sagittal (for two levels of section; one lateral to include kidney and one midline) 1
2 Whole Placenta Cross section at midline through the umbilical cord 1

 

Parameters & Metadata

Name Version Type Req. Upload Req. Analysis Annotation Increment Option Derived Unit Data Type
Name Version Type Req. Upload Req. Analysis Annotation Increment Option Derived Unit Data Type